Wood floor after being treated with Stripsol LO.
View Product Gallery

Stripsol LO

Non-Hazardous Stripping Agent

Stripsol LO (Low Odor) is a solvent-based sealer, stain, and paint stripper with a wide range of applications. Stripsol LO will remove layers of acrylics, acrylic latexes, polyurethane, and other resin coatings. The product’s low odor allows it to be used indoors and out.
Alkyd enamels can be stripped using a two-step process: First apply Stripsol LO. Then, while still wet, apply Stripper Cream. Stripsol LO causes little to no damage on most substrates, including wood, glass, metals, aluminum trim, and masonry surfaces.
Advantages
  • Non-flammable
  • Does not burn skin
Stripsol LO Product Spec Sheet
Stripsol LO Safety Data Sheet
Architectural Spec Sheets

Dilutions:

Use undiluted (straight).

Coverage Rates:

Coverage rates will vary from 125-250 sq. ft. per gallon depending on the surface porosity, texture and severity of staining.

Application Instructions:

Before applying, read “Preparation” paragraph section and “Precautionary Measures” under Safety Information in product specification sheet.
Stripsol LO is best applied through a low-pressure application system when outdoors, but it can be brushed, wiped, or rolled on to the surface.
Depending on the paint or coating, more than one application may be needed. Apply the stripper from the top down using a side-to-side motion. A small hand pump garden sprayer works well for small jobs.
Allow Stripsol LO to dwell for at least five minutes before doing a scratch test. Scratch at the paint or coating with a sharp object to see if the substrate is visible. If the substrate is visible where tested, then it is ready to be rinsed. If the substrate is not visible or if the coating is gummy but not released, without rinsing re-apply and let dwell for an additional ten minutes before re-testing.
Be careful not to leave foliage covered for too long in direct sunlight, as it may cause damage. 

Rinsing:

A pressure washer, garden hose, or water and scrub brush can be used for rinsing. When using a pressure washer, keep the nozzle six inches from the surface if rinsing wood. Do not allow product to dry on the surface. Always rinse off thoroughly while wet.

Send us your inquiry and we'll get right back to you!

EaCo Chem, Inc. | 765 Commerce Avenue | New Castle, PA | (724) 656-1055 | info@eacochem.com

Please enable JavaScript in your browser to complete this form.
Name
To better serve you, please select the EaCo Chem Product you are inquiring about.