EC 102 SOL
Silicone-Based Sealer for Masonry
EC 102 SOL forms uniform, long lasting, water repellent coating on pavers, concrete surfaces, brick, and split-faced block. This coating enhances the surface without leaving the surface slippery when used on horizontal surfaces. Efflorescence problems can be dealt with even after the coating has been applied. EC 102 SOL protects from water, normal wear, and some food and oil stains.
Application Instructions:
Temperatures should be between the range of 50° and 85° Fahrenheit before applying. Apply at a rate of approximately 200-square feet per gallon to achieve an even coating. If you’re spraying with low pressure equipment, spray until the material just begins to run on the surface. Over saturation will not give any better protection.
Take care not to get the material on glass or any surface that is intended to be painted, as paint will not adhere to a coated surface. There will be a slight darkening of the surface with this material.
Do not apply this material to a wet or damp surface. The substrate should have a minimum of twenty four (24) hours to dry before application. The EC 102 SOL should not be applied when rain is expected within the next four hours. Refer to Product Data & Specification Sheet before use.
Advantages:
Reacts with the substrate for excellent bonding and adhesion
Easy application (no mixing, low pressure spray)
Easy re-coating for touchups
Unaffected by most cleaners
Shows long term water repellency
Works on old and new substrates
Protects from water and most food and oil stains
Dilution:
EC 102 SOL is a ready to use sealer. No dilution or mixing is recommended or required.
Limitations:
• Product should not be applied below 50˚F or
above 85˚F.
• Do not use on polished surfaces.
• Protect from freezing
