[an error occurred while processing this directive]

SPECIFICATION DATA Go Back Materials Safety Data SheetsProduct RequestProduct Support

POLISHED STONE CLEANER NEUTRAL

Interior marble cleaner for floors and walls

Description and Use:
This unique chemistry is a neutral cleaner with a lot of advantages for interior cleaning. A very mild pleasant odor and non-corrosive non-hazardous components make it safe for both the user and the environment. P.M.C. is capable of removing smoke, heavy finger soils, sealers and waxes, and foot traffic soil without any harm to the marble substrate. Another real benefit of the product is that it does not foam on pickup, so that if you must vacuum the residue you will not waste time clearing foam or de-foaming. All these characteristics make the soap readily disposable to sanitary sewer or easily treated in a waste reclaim system.

Advantages:
* Renews the surface of the marble without any hazards.
* Neutral pH makes the soap personally and environmentally safe.
* Low foaming non-emulsifying characteristics make it great for disposal or treatment.

Limitations:
* The undiluted or highly concentrated product should not be left on a painted surface too long. This can be evened
   out by reapplication of the product over the area and rinsing properly.
* This product may dry out skin if used over prolonged periods of time without gloves.

Technical Data:
Appearance & Odor: Mild odor, colorless
Physical State: Liquid.
pH: 7.8
Vapor Pressure (mmHg): as water
Vapor Density (air=1): as water
Boiling Point: 210° F
Freezing/Melting Point: 32° F
Specific Gravity (Water =1): 1.07
Evaporation Rate: N/A
Solubility in water:
Complete Protection: Gloves and Goggles.

Application Information
The product may be applied by spray, brush, wipe, or sponge at the recommended dilutions. Agitate as needed or simply allow adequate dwell time on the surface for the soil to be wiped mopped or sprayed away. Rinse depends on surfaces to be cleaned and dilutions. At high dilutions no rinse may be needed but at the stronger concentrations you will need to rinse away the softened soil with a spray or clear mop.

Pre-Testing
Always test prior to beginning full-scale cleaning operations.

Dilutions
P.M.C. can be cut with water up to 50:1 for regular light duty cleaning. Removing smoke damage or sealers requires the product to be used undiluted or up to a 4:1 cut. When removing heavy finger soil or foot traffic dirt cut the product from 4:1 to 20:1

Coverage Rates
Coverage will be based on dilution.

Safety Information:
Precautionary Measures: You may wear goggles and rubber gloves when handling this product. Keep off of skin and clothing. If material comes in contact with clothing, wash before reuse. No Hazardous Ingredients. Not regulated by the DOT. Keep container closed when not in use. Dispose of empty containers according to federal, state and local requirements. Do not remove label. Read Material Safety Data Sheet for additional safety and health hazard information prior to use.

 

First Aid +
Eyes: Flood with water 15 minutes and call physician.
Skin: Wash off with soap and water. If irritation develops, call physician.
Inhalation: Remove to fresh air.
Ingestion: Drink large volume of water. Call Physician if irritation develops.

Spill or Leak Procedures:
Waste Disposal Method: Check state, local or federal regulations in your area. Steps to be taken if material is released or spilled: Large spill; dike and contain for intended use. Small spill: Absorb on oil dry and place in approved container for disposal.

Container Handling/Storage
Store in a cool, dry place. Keep container tightly closed when not in use. If frozen, thaw & agitate before use.

Disclaimer
The information herein is given in good faith, but no warranty, either expressed or implied is made. Final determination of the suitability of any material is the sole responsibility of the user. All materials may present unknown hazards and should be used with caution. Although certain hazards are described herein we cannot be sure or guarantee these are the only hazards, which exist.

Customer Service
Factory personnel are available for assistance at 800-313-8505 and will send you additional information on products as necessary.



© Copyright 2002 by EaCo Chem


Search EaCo Chem Database

Product Categories
Acids
Concrete Cleaners
Degreasers
House and Deck Cleaners
Limestone Cleaner & Marble
New Masonry Detergents
Paint Strippers
Restoration Detergents
Specialty Products
Truck Washing Soaps
Windows & Wall Cleaning


Learning Centers
Aluminum Cleaning
Limestone Restoration
Modern Surfaces
New Construction
Paint Stripping
Restoration
Slurry Dyed Block
Terra-Cotta
Truck Washing


Services
Contact EaCo Chem
Products By Application
Request Literature


EaCo Chem Info
About EaCo Chem Inc
News
< Return Home