PLUS

High Pressure Degreaser

Description and Use
PLUS is designed for the maximum in power and safety. It will remove very heavy grease from heavy equipment and rolling stock; yet will not harm the paint on the equipment being cleaned. PLUS is designed to enable the user to clean most soils from paint without brushing or resorting to high pressure application. PLUS is a through the pressure washer type degreaser that can be applied at high dilutions to save you money. This solution works well in hot or cold water though when used in hot it will also clean the pressure washer coils as it works. With a good rinse PLUS leaves no film or water spots on glass. There are no hazardous ingredients in PLUS.

Advantages
*Safe on paint. *Saves money with high dilutions. *No hazardous ingredients.

Limitations
*Not safe for polished aluminum at normal strength. *Product effectiveness limited if frozen.

Technical Data
Appearance-Odor: Light amber colored liquid. Mild odor when sprayed.
Physical State: Liquid.
pH: 12
Vapor Pressure (mmHg): N.A. Vapor Density (air=1): N.A.
Boiling Point: 212° F
Freezing/Melting Point: N.A
Specific Gravity (Water=1): 1.090
Evaporation Rate: As water.
Solubility in water: Complete.

Surfaces and Air Temperatures
Best cleaning results are obtained when air is above 40°F.
Pre-testing prior to beginning full-scale cleaning operation. Testing should confirm cleaning effectiveness.

Dilutions
15:1 to 30:1 for degreasing trucks and heavy equipment. 20:1 to 50:1 for brushless truck washing. 100:1 for brush type cleaning (1 gallon water to 4oz of PLUS).

 Application Instructions
This product can be applied by low pressure at 30 to 100 psi or high pressure up to 3000 psi. For best results use pressures between 500 to 3000 psi. If high pressure is not available, you can rinse with a garden hose. Do not allow the soap to dry on surface.

Safety Information
Precautionary measures: always wear goggles and rubber gloves when handling this product. Keep off of skin and clothing. If material comes in contact with clothing, wash before reuse. Do not get in eyes, on skin or clothing. Keep container closed when not in use. Do not allow product to freeze. Do not remove label. Read Material Safety Data Sheets for additional safety and health hazard information prior to use.

First Aid +
Instructions in Case of Contact or Exposure
EYES: Flush with water for 15 minutes. If irritation develops, call physician.
SKIN: wash with soap and water. If irritation develops, call physician.
INGESTION: Drink copious amounts of water, call a physician.
INHALATION: Remove to fresh air.

Spill or Leak Procedures Waste Disposal Method:
Check state, local or federal regulations for your area. Steps to be taken if material is released or spilled: Large spill: Dike and contain for intended use. Small spill: absorb on oil dry and place in approved container for disposal.

Container Handling/Storage
Keep container closed when not in use. Store above 40°F

Disclaimer
The information herein is given in good faith, but no warranty, either expressed or implied is made. Final determination of the suitability of any material is the sole responsibility of the user. All materials may present unknown hazards and should be used with caution. Although certain hazards are described herein we cannot be sure or guarantee these are the only hazards which exist.

Notice
This product has been classified in accordance with the hazard criteria of the CFR.

Customer Service
Factory personnel are available for assistance at 800-313-8505 and will send you additional information on products as necessary.