Plexi-Clean

Plexiglass cleaner

Description and Use
Plexi-Clean is made to safely clean plexiglass and remove graffiti. This product will not smoke or craze. This product is excellent for bus windows, phone booths... Use Plexi-Clean straight and apply with either a low pressure sprayer or wipe it on with a cloth. Often just a wipe with a damp cloth is all that is necessary to remove the paint or ink. As with all strippers, proper testing of the material on the area to be cleaned is the only way to determine the correct procedure. It works best at room temperature, 60-80° F. Sometimes two applications are needed. Wet on wet application with a short dwell time prior to removal.

Technical Data
Appearance & Odor: Clear liquid, butyl odor
Physical State: Liquid
Vapor Pressure (mmHg): as water
Boiling Point: 210° F
Specific Gravity (WATER=1_: 1.001
Solubility in water: complete
pH = 9.5 Vapor Density (air=1) = as water
Freezing/Melting Point = N/A
Evaporation Rate: as water

Surface & Air Temperatures
Best cleaning results are achieved when product is at room temperature 60-80° F

Pre-Testing
Always test prior to beginning full-scale cleaning operations. Testing should confirm effectiveness on each type of surface and stain to be cleaned.

Dilutions
Apply straight

Application Instructions
Product can be applied straight with either a low pressure sprayer unit or wiped on with a cloth. Wipe off with a damp cloth. Sometimes two applications are needed. Wet on wet application with a short dwell time prior to removal.

Safety Information
Precautionary Measures: Always wear goggles and rubber gloves when handling this product. Keep off of skin and clothing. If material comes in contact with clothing, wash before reuse. Avoid breathing fumes. Keep container closed when not in use. Use with adequate ventilation. Dispose of empty containers in accordance with federal, state and local requirements. Do not use for any other applications not specified. Do not remove label. Read Material Safety Data Sheets for additional safety and health hazard information prior to use.

First Aid +
Instructions in Case of Contact or Exposure Skin & Eye Contact:
Eyes: Flush thoroughly with water for fifteen minutes. If irritation develops, call physician.
Skin: Wash off with soap and water. Follow with a good skin emollient. If irritation persists, seek medical attention.
Ingestion: Drink copious amounts of water. Call physician.
Inhalation: Remove to fresh air. If irritation persists, call physician.

Spill or Leak Procedures / Waste Disposal Method:
Check federal, state and local regulations in your area. Steps to be taken if material is released or spilled: Large Spills: Dike and contain for intended use. Small spill: Absorb with oil dry and dispose of properly.

Container Handling and Storage
Keep container closed when not in use. If frozen, thaw and agitate before use.

Disclaimer
This information is given in good faith, but no warranty, either expressed or implied is made. Final determination of the suitability of any material is the sole responsibility of the user. All materials may be present unknown hazards and should be used with caution. Although certain hazards are described herein we cannot be sure or guarantee these are the only hazards which exist.

Customer Service:
Factory personnel are available for assistance at 800-313-8505 and will send you additional information on products as necessary.