DAZZLE

Brushless Polished Aluminum Truckwash

Description and Use
A one step brushless truckwash that is safe for polished aluminum at any strength. Dazzle has very good foam when applied through a pressure washer but rinses quickly and cleanly. One quick application of the product and you will see the film being cut and diesel smoke loosen immediately. There is no unpleasant odor or skin burn while using Dazzle either. Because there are no caustic or butyls in this soap it is very safe for indoor use and generally does not harm high quality waxes.

Advantages
*Safe on polished aluminum.
*One step brushless system.
*No skin burn or unpleasant odor.

Limitations
*Not appropriate for most reclaim systems.

Technical Data
Appearance & Odor: Clear liquid, mild odor.
Physical State: Liquid
pH: 10.5
Vapor Pressure (mmHg): N/A
Vapor Density (air= 1) : >1
Boiling Point: 212° F
Freezing/Melting Point: 32° F
Specific Gravity (WATER =1): 1.04
Evaporation Rate: <1
Solubility in Water: Complete
Surface & Air Temperatures:
Best cleaning results are obtained when air is above 40° Fahrenheit.

Pre-Testing
Always test prior to beginning full-scale cleaning operations. Testing should confirm cleaning effectiveness.

Dilutions
10:1 or 30:1 through a pressure washer up stream or down 30:1 or 100:1 brushless strength.

Application Instructions
This product may be applied downstream or upstream through a pressure washer or by means of low pressure applicator or by brushing Rinsing is best accomplished with a pressure washer or with a garden hose after brushing. Do not allow the product to dry on the glass.
 
Safety Information
*Precautionary Measures: Always wear goggles and rubber gloves when handling this product. Keep off of skin and clothing. If material comes in contact with clothing, wash before reuse. Contains Sodium Metasilicate and Ethylene diamine tetracetic acid. Do not get in eyes, on skin or clothing. Avoid breathing fumes. Keep container closed when not in use. Use with adequate ventilation. Applicators should wear rain suit of plastic, rubber or PVC, boots and gloves, face shields and goggles to avoid splash to bare skin or eyes. Dispose of empty containers according to federal, state and local requirements. Do not use for any other applications other than specified. Do not remove label. Read Material Safety Data Sheet for additional safety and health hazard information prior to use.

*First Aid +
Instructions in Case of Contact or Exposure Skin & Eye Contact:
Eyes: Flush with water for 15 minutes. If irritation persists consult physician.
Skin: Flood with water. If irritation develops, call physician. Inhalation: N/A
Ingestion: Drink copious amounts of water. Seek medical attention.
 

Spill or Leak Procedures
Local or federal regulations for your area. Steps to be taken if material is released or spilled: wear proper protective equipment while doing cleanup. Large spill: Dike and contain for intended use. Small spill: absorb on oil dry and place in approved container for disposal.

Container Handling/Storage
Keep container closed when not in use. Store in containers with Viton seals or silicon sealant gaskets.

Notice
This product has been classified in accordance with the hazard criteria of the CFR.

Disclaimer
The information herein is given in good faith, but no warranty, either expressed or implied is made. Final determination of the suitability of any material is the sole responsibility of the user. All materials may present unknown hazards and should be used with caution. Although certain hazards are described herein we cannot be sure or guarantee these are the only hazards which
exist.

Customer Service
Factory personnel are available for assistance at 800-313-8505 and will send you additional information on products as necessary.