[an error occurred while processing this directive]

SPECIFICATION DATA Go Back Materials Safety Data SheetsProduct RequestProduct Support

ALUMIX

Hydrofluoric Acid Aluminum Brightener

Description:
A very aggressive hydroflouric acid based aluminum brightener that leaves a very nice soft shine on the surface. This is a high strength aluminum cleaner that is not safe on glass and should not be handled in the BC state without extensive safety precautions. This is the concentrate that will make Alumix blends 50, 30, or Mild. The diluting procedure should be done with full safety gear on and it is especially important to protect the eyes. Hydroflouric acid burns people both on the skin and under it. Goggles and gloves and proper protective gear should be worn at all times when using a hydroflouric product. This blend at use dilution is much safer than the concentrated material but it is wise to seek medical attention if the concentrate goes on your skin. Vaseline on the skin before spraying may help reduce redness but will not prevent acid burning.

Directions:
This product after dilution may be applied downstream through a pressure washer or by means of low pressure applicator or by brushing Alumix 50 is best used outside on very dirty aluminum trailers but can be used for two stepping in cases of extreme soil. Alumix 30 is best used in truckwash tunnels where OSHA exposure limits are a concern and rail brightening or two step cleaning is the aim. Alumix Mild is for two step truck washing only.

Dilutions:
Alumix BC 5 gallons in a 55 gallon drum = Alumix 50
Alumix BC 3 gallons in a 55 gallon drum = Alumix 30
Alumix BC 1 gallon in a 55 gallon drum = Alumix Mild

First Aid:
Always wear proper eye and skin protection with this product. If in contact with the dilute product rinse skin thoroughly for fifteen minutes and if pain occurs seek the care of a physician. For any eye contact rinse thoroughly with cool clean water and seek immediate medical attention. For skin contact with the concentrate seek medical attention after flooding skin with water for fifteen minutes.

Right to know ingredients:
Hydroflouric acid 7664-39-3
Sulfuric acid 7664-93-9
Water 7732-18-5

Notice:
This product has been classified in accordance with the hazard criteria of the CFR.

Disclaimer:
The information herein is given in good faith, but no warranty , either expressed or implied is made. Final determination of the suitability of any material is the sole responsibility of the user. All materials may present unknown hazards and should be used with caution. Although certain hazards are described herein we cannot be sure or guarantee these are the only hazards which exist.

Customer Service:
Factory personnel are available for assistance at 800-313-8505 and will send you additional information on products as necessary.

 

 



© Copyright 2002 by EaCo Chem


Search EaCo Chem Database

Product Categories
Acids
Concrete Cleaners
Degreasers
House and Deck Cleaners
Limestone Cleaner & Marble
New Masonry Detergents
Paint Strippers
Restoration Detergents
Specialty Products
Truck Washing Soaps
Windows & Wall Cleaning


Learning Centers
Aluminum Cleaning
Limestone Restoration
Modern Surfaces
New Construction
Paint Stripping
Restoration
Slurry Dyed Block
Terra-Cotta
Truck Washing


Services
Contact EaCo Chem
Products By Application
Request Literature


EaCo Chem Info
About EaCo Chem Inc
News
< Return Home